Alternatively you could use PRTG which is free (up to 100 sensors) but you'll need to configure SNMP on each device. Device credentials can also be retrieved from the previous UniFi controller under Settings > Site > Device Authentication 6. S7|E29 Increase Visibility and Enhance Security with Cisco AI Endpoint Analytics Once device reboots, SSH into the device again and type the following command, substituting the 'ip-of-controller' with the IP address of the host of the UniFi Network Controller: 4. If you do not have management access to this modem/router, contact your ISP provider to make this configuration change.If a UniFi device shows the LED pattern for 'ready and waiting adoption', but is not discoverable to adopt, and does not appear in the UniFi Network Controller's Devices section as 'pending adoption' please follow these steps.1. Watch the Controller Logs when attempting to adopt a device.
